Woven Pendant
using circle tool, draw circle with diameter of 50 mm and offset it by 1.5 mm
Press on "Show object control points" tool to see all the control points.
Click every second point and drag one space to the right, then highlight the left points and drag one space to the left. This creates a zig-zag pattern.
Hide Control points again. Using Pipe tool, select the curve and press enter, type in 0.6
Rotate and copy the pipe again by 90 degrees and then copy and rotate that same pipe by 180 degrees again so it flows in the opposite direction.
Click on both curves created with previous commands and extrude by 10 mm.
No comments:
Post a Comment